69
PRIMERGY TX120 User’s Guide
3
OS Installation Using ServerStart
3.2 Preparation Mode
In preparation mode, set and save the information necessary for installation in a
configuration file on a client computer (with a CD-ROM drive and 10MB or more of
free space). Set the saved configuration file on the server for installation.
` If ServerStart is not installed in the client computer where the preparation mode is executed, refer to
"2.4 Preparation for Using ServerStart on a Client Computer" (Jpg.46) to install ServerStart. If a
different version of ServerStart has been installed, uninstall it and install the proper version. For details
on how to uninstall ServerStart, refer to "2.4.2 Uninstalling ServerStart" (Jpg.48).
` Prepare the ServerStart floppy disk. When using a formatted commercial-release disk, create the
ServerStart floppy disk in advance, referring to "2.4.3 Creating the ServerStart Floppy Disk" (Jpg.49).
3.2.1 Starting Up the Preparation Mode
Start up the preparation mode.
1 Start up ServerStart.
If ServerStart has already been started, it is not necessary to start it up again. If it has not, start it
up according to the following procedures:
1. Click [Start] → [Programs] → [Fujitsu Siemens ServerStart] → [ServerStart(Start
from CD)].
ServerStart starts up and the [Welcome to ServerStart] window appears.
2 Click [Click here to prepare an operating system installation for a PRIMERGY
Server].
The [Prepare the installation of an operating system for PRIMERGY Server] window appears.