Fujitsu Primergy TX120 User Manual

86
Chapter 3 OS Installation Using ServerStart
3.4.3 Preparation of the PXE Server (When the PXE Server
is Used)
When performing remote installation using a PXE server, preparatory procedures, such as installing
ServerStart, are required.
Perform the following procedures to prepare the PXE server.
 Starting the DHCP Service
Check that the DHCP service is running on the same network.
If the DHCP service function is not installed, perform the following procedures to install the DHCP
service. The following procedures are examples for Windows Server 2003.
1 Click [Start] → [Control Panel] → [Add or Remove Applications].
2 Click [Add or Remove Windows Components]. Click the [Dynamic Host
Configuration Protocol (DHCP)] service from [Network Services].
The DHCP service is installed.
3 Create and configure a DHCP scope so that the IP address can be distributed.
Starting the DHCP Service
Installing ServerStart
Checking Services
Setting TFTP
Preparation of Resources

Fujitsu Primergy TX120 Specifications

General

Brand	Fujitsu
Model	Primergy TX120
Category	Server
Language	English