169
PRIMERGY TX120 User’s Guide
Installing hardware options
7
7.4 Installing Expansion Cards
This section explains the types of expansion card, notes and installation procedures.
• When installing or removing an expansion card, turn off the server, all
peripheral devices, and any other connected devices. Also unplug all power
cables from the outlet.
Failure to do so can cause electric shock.
• Install our genuine expansion cards only.
Failure to do so may cause a device failure, fire, or electric shock.
• Wait for a sufficient period of time after server shutdown before installing or
removing expansion cards.
Failure to do so can cause burns.
injury
• When installing or removing expansion cards, make sure to remove the screws
at the specified locations only.
There is a risk of injury if screws other than those at the specified locations are
removed. This could also damage the server.
• Touch only the specified part of the printed circuit board.
Failure to do so could cause injury and also damage the server.
• Do not touch metal fixings of the main board on the rear side of the server.
This could cause injury. This could also damage the server.
• Expansion cards are made of delicate components that are extremely
sensitive to static electricity, and they can be destroyed by static electricity
from your clothes or body. Before handling them, first touch some metallic
object to discharge static electricity.
To Next Page
Loading...
Need help?
General