128
Chapter 5 Operations after OS Installation
8 Select [Custom size] and enter a value in [Initial size].
The value depends on the type of the set dump file.
Specify a value larger than the value shown in [Recommended] in [Total paging file size for all
drives].
` When a smaller value is specified for the paging file size, performance may be affected. For
maximum system efficiency, be sure to set [Initial size] with a value larger than the [Recom-
mended] size described in [Total paging file size for all drives]. The recommended size is total
memory installed in the system x 1.5. However, if a program consuming a large amount of
memory is regularly used, set a larger size as required.
9 Enter a value in [Maximum size].
Specify a value larger than the [Initial size].
10 Save the settings.
Click [Set] in the [Paging file size for selected drive] section.
The settings are saved, and the value specified is displayed in [Paging File Size] of [Drive].
11 Click [OK] to close the [Virtual Memory] window.
12 Click [OK] to close the [Performance Options] window.
13 Click [OK] to close the [System Properties] window.
14 Restart the system.
The setting is enabled after the system is restarted.
About reboot after OS Dump settings.
For OS Dump settings, even if reboot after obtaining the dump is set, it may not reboot at hardware
failure. Hardware failure should be fixed immediately, however, when uninterrupted operation is
necessary, set reboot with Software Watchdog. For details and setting procedures for Software
Watchdog, refer to "3.4 Serious Error Handling (ASR)" in "ServerView User's Guide" on the
PRIMERGY Document & Tool CD.
To Next Page
Loading...
