Fujitsu Primergy TX120 - Page 161

161
PRIMERGY TX120 User’s Guide
Installing hardware options
7
• Before installing/removing internal options to/from the server, turn off the
server, all peripheral devices, and any other connected devices. Also unplug
all power cables from the outlet. Failure to do so can cause electric shock
("1.4.3 Turning Off the Server" (Jpg.31)).
• Do not disassemble the PSU. Doing so can cause electric shock.
• Use our genuine internal options only. Failure to do so may cause a device
failure, fire, or electric shock.
• Do not damage or modify internal cables or devices. Doing so may cause a
device failure, fire, or electric shock.
• Devices inside the server remain hot after shutdown. Wait for approximately
10 minutes after shutdown before installing or removing internal options.
• The circuit boards and soldered parts of internal options are exposed. They
can be damaged by static electricity.
Before handling them, first touch a metal part of the server to discharge static
electricity.
• Do not touch the circuitry on boards and soldered parts. Hold the metallic
areas or the edge of the circuit boards.
• When installing an internal bay option, make sure to avoid pinching cables.
• If devices are installed or disassembled by other methods than those outlined
in this chapter, the warranty will be invalidated.