Field Value
quest is accepted.
• -"0""3 : A negative answer to a request is not
accepted. A request is sent to the next RADIUS server until
your device receives an answer from a server configured as
authoritative.
UDP Port Enter the UDP port to be used for RADIUS data.
RFC 2138 defines the default ports 1812 for authentication
(1645 in older RFCs) and 1813 for accounting (4,180.84 cm
older RFCs). You can obtain the port to be used from the docu-
mentation for your RADIUS server.
The default value is .
Server Timeout Enter the maximum wait time between ACCESS_REQUEST
and response in milliseconds.
After timeout, the request is repeated according to Retries or
the next configured RADIUS server is requested.
Possible values are whole numbers between and .
The default value is (1 second).
Alive Check
Here you can activate a check of the reachability of a RADIUS
server in Status4.
An Alive Check is carried out regularly (every 20 seconds) by
sending an ACCESS_REQUEST to the IP address of the RADI-
US server. If the server is reachable, Status is set to ,3
again. If the RADIUS server is only reachable over a switched
line (dialup connection), this can cause additional costs if the
server is for a long time.
The function is activated by choosing 7#,.
The function is activated by default.
Retries Enter the number of retries for cases when there is no response
to a request. If an answer has still not been received after these
attempts, the Status is set to . If the Active Check = 7
#,your device tries to reach the server every 20 seconds. If
the server answers, the Status is set back to ,3.
Funkwerk Enterprise Communications GmbH
5 System Management
funkwerk W1002/W2002/WIx040/WIx065 103
To Next Page
Loading...
Need help?
General
