2.5.1.1 Gathering data
The main data for the basic configuration can be gathered quickly, as no information is re-
quired that needs in-depth network knowledge. If applicable, you can use the example val-
ues.
Before you start the configuration, you should gather the data for the following purposes:
• IP configuration (obligatory if your device is in the ex works state)
• Optional: Configuration of a wireless network connection in Access Point mode
• Optional: Configuration of client links in Client Links mode
• Optional: Configuration of bridge links in Bridge mode.
The following table shows examples of possible values for the necessary data. You can
enter your personal data in the "Your values" column, so that you can refer to these values
later when needed.
If you configure a new network, you can use the given example values for IP addresses
and netmasks. In cases of doubt, ask your system administrator.
Basic configuration
For a basic configuration of your gateway, you need information that relates to your net-
work environment:
IP configuration of the access point
Access data Example value Your values
IP address of your access point
Netmask of your access point
Access Point mode
If you run your device in Access Point mode, you can set up the required wireless net-
works. To do this, you need the following data:
Configuration of a wireless network
Access data Example value Your values
Network Name (SSID)
Security Mode
Preshared Key ! "
Access Client mode
2 Quick Install Guide Funkwerk Enterprise Communications GmbH
16 funkwerk W1002/W2002/WIx040/WIx065
To Next Page
Loading...
Need help?
General
