Note
Make sure the cursor is positioned in a list element. The search cannot run if the curs-
or is located in a command field, e.g. ADD or DELETE.
In the menu shown above, the entries provide the following search results:
Search results
Input Cursor jumps to entry
" or ) Visitors
- , . , - , . BigBoss
+ Department1, on entering to Department2
4.3.2.4 Changing the Password
The procedure described below for changing the password applies to all passwords on
your device: the access passwords for the user names , and 4, the HTTP
password, the PPP password and the provider password.
Any character may be used for entering a password. Passwords are only displayed as as-
terisks, even while changes are being made. The number of asterisks is the same as the
number of characters in the password.
Note
To start the Setup Tool of your device in a mode in which the passwords are displayed
in plain text and can be changed by one-time editing, you must enter the command
! %. This option only exists if you have logged in on your device with the user
name . In the password field, the Backspace key always deletes the complete
entry, not just one character.
Proceed as follows:
(1) Select the password field in the desired menu and enter the new password.
(2) The field changes to the change mode and the message 7' 4 appears
in the help line.
(3) Now press Return, Tabulator or a Cursor key to confirm. The field changes to the
confirm mode and 7 4 is displayed in the help line.
(4) Now enter the new password again and confirm by pressing Return, Tabulator or a
Cursor key. If you have entered the repeat password correctly, the password is
changed. The new password is saved on leaving the menu with the SAVE button. If
4 Access and Configuration Funkwerk Enterprise Communications GmbH
74 funkwerk W1002/W2002/WIx040/WIx065
To Next Page
Loading...
