FUTABA T10J - Throttle Cut

129
Helicopter
Function
Method
①Callthemenuscreenfromthe
homescreenbypressingthe +
keyfor1second.
＋
② Select
fromthemenuwiththe
Jogkey.
③Openthesettingscreenby
pressingtheJogkey.
（1second）
Callingthesettingscreen
This function cuts (stops) the engine or motor
by stick operation. At throttle operation, the rate
is adjusted to the position which completely cuts
the throttle servo or ESC when the throttle is
operated. At function operation, this position is
held regardless of the throttle stick position.
ŏ125(6&RSHUDWLRQPRGHVZLWFKLQJ)RUPRWRU
DLUFUDIWVHOHFW(6&)RUPRWRUDLUFUDIWWKHWKURWWOH
SRVLWLRQZKHQWKHIXQFWLRQLVUHVHWFDQEHVHWVR
WKHPRWRUZLOOQRWXQH[SHFWHGO\UXQDWKLJKVSHHG
ZKHQWKHWKURWWOHFXWIXQFWLRQLVUHVHW:KHQWKH
WKURWWOHVWLFNLVKLJKHUWKDQWKHVHWWKURWWOHSRVLWLRQ
WKHWKURWWOHFXWIXQFWLRQLVQRWUHVHWHYHQLIWKH
VZLWFKLVVHWWR2))6HWWRDVDIHWKURWWOHSRVLWLRQ
VORZVLGH
ŏ)XQFWLRQRSHUDWLRQFDQEHVHOHFWHGIURPDPRQJ
VZLWFKHV$
〜
+
ŏ6HWWKHWKURWWOHFXWIXQFWLRQIRUVDIHW\DOVR
"THR.CUT"
THR.CUT
Throttlecut
(HELICOPTER)
Mode
Activatingthefunction
CutPositionrate
ThrottlePosition
Switchselection
Switchdirection
● WhennotusingthisFunction
selectINH.ThedisplayofOn/
Offisshownwhenactiveand
assignedtoaswitch.
● Adjuststheratetotheposition
thatcompletelycutsthe
throttleservoorESC.
● The"THR"itemcanbeset
whentheoperationmode
is"ESC".Thenumberin
parenthesesisthecurrent
throttlestickposition.
● Selectthesettingitem
withtheJogkey.
● SetstheON/OFFdirectionoftheselectedswitch.
○ 2PSW：NULL,UP,DOWN
○ 3PSW：NULL,UP,UP&D,UP&C,CNTR,C&DN,DOWN
7+5&87