FUTABA T10J - Parameter Function; Data Reset (Reset); Model Type (Type); ATL Trim (ATL)

58
Commonfunction
Function
PARAMETER submenu: sets those parameters
you would likely set once, and then not disturb
again.
Once you have selected the correct model you
wish to work with, the next step is setting up the
SURSHUSDUDPHWHUVIRUWKLVVSHFL¿FPRGHO
Datareset（RESET）
Thepresentmodeldataisreset.DataResetdoesNOTreset,ATLTrim,TELEMETRYmode,orSTKPOSI
Alarm.
Modeltype（TYPE）SWASH:OnlyhelicopterWING:Onlyglider
MODELTYPE:setsthetypeofprogrammingusedforthismodel.
TheT10Jhas30modelmemories,whichcaneachsupport:
●
Onepoweredaircraft(ACRO)memorytype(withmultiplewingandtailconfigurations.Seetwin
aileronservos,twinelevatorservos,ELEVON,andV-TAILforfurtherinformation.)
●
Eighthelicopterswashplatetypes,includingCCPM.SeeHelicopterMODELTYPEfordetails.
● IfyouuseCGY750,theswashtypeshouldchooseH-1. (SwashtypeischosenbysetupinCGY750.）
●
Fivegliderwingtypes.SeegliderWINGTYPEfordetails.
●
Multicoptertype.
Beforedoinganythingelsetosetupyouraircraft,firstyoumustdecidewhichMODELTYPEbestfits
thisparticularaircraft.(Eachmodelmemorymaybesettoadifferentmodeltype.)Ifyourtransmitter
isaT10JA,thedefaultisACRO.IfitisaT10JH,thedefaultisHELI(H1).
ATLTrim（ATL）
Adjustabletravellimit(ATL):makesthechannel3TRIMLEVER(THROTTLETRIM)effectiveonlyat
lowthrottle,disablingthetrimathighthrottle.Thispreventspushrodjammingduetoidlingtrim
changes.ThisfunctiondefaultstoON.Ifyouarenotusingchannel3forthrottle,youmaywant
trimoperationthesameasonallotherchannels.Todoso,setATLtoOFF.IfyouneedtheATLtobe
effectiveatthetopofthestickinsteadofthebottom,reversetheTHR-REVsetting.Notethatthis
affectsallmodelsintheradio,notjustthemodelyouarecurrentlyediting.
LCDcontrast（CONTRAST）
ContrastadjustmentLCDscreen.
● Youadjusttolegiblecontrast.setuprange-10 〜 +10
Backlight（BACK-LIT）
BacklightmodeofaLCDscreencanbechosen.
● ALWAYS/KEY-ON(Shinesforadefiniteperiodoftimeafterkeyoperation.)/OFF
Lighttime（LIT-TIME）
Setsthelengthoftimethebacklightwillstayon.
● Setuprange1 〜 30
Lightadjustment（LIT-ADJS）
Lightvolumeadjustmentofabacklight.
● Setuprange1 〜 30
Homedisplay（HOME-DSP）
Itemselectiondisplayedonahomescreen
● Futabalogo(Default),USR-NAME,RXBATT,DT5/DT6,THR/PIT(Caseofhelicopter,thepositionofa
throttleandpitch.)
PARAMETER
Parameterfunction
(Common)