FUTABA T10J - Rudder-Aileron (Glider)

158
Glider
Function
Method
①Callthemenuscreenfromthe
homescreenbypressingthe +
keyfor1second.
＋
② Select
fromthemenuwiththe
Jogkey.
③Openthesettingscreenby
pressingtheJogkey.
（1second）
Callingthesettingscreen
1AIL 2AIL 2AIL+1F 2AIL+2F 2AIL+4FWINGTYPE
■ Activatingthefunction
①Selectthe"MIX"itemandthenselect
the"ON"bypressingthe+keyor‒
key.
＋ −
or
● Whenyoudonotuseafunction,set
tothe"INH"side.
■ Mixingrate
＋ −
or
②Selectthe"RATE"itemand
thenadjustthemixingrateby
pressingthe+keyor‒key.
Range：-100 〜 +100%
Default：0%
● Whenyouwanttoreturnthesetvaluetotheinitialvalue,
pressthe+keyand‒keysimultaneously.However,
polaritydoesnotreturn.
RUD → AIL
This function is used when you want to mix
the ailerons with rudder input. It is used when
rudder is applied during roll maneuvers such
as, knife edge flight. It can be used to turn or
bank scale models, large models, etc. like a full-
size aircraft.
ŏ:KHQWKHPL[LQJGLUHFWLRQLVUHYHUVHGE\WKH
OLQNDJHDGMXVWPHQWVFDQEHPDGHE\FKDQJLQJ
WKHUDWHSRODULW\
"RUD → AIL"
RUD → AIL
Rudder → Aileron
(GLIDER)

Activatingthefunction
Mixingrate
● Whennotusingthisfunction,
selectINH.
● Selectthesettingitem
withtheJogkey.
● TheON/OFFswitchcanbechanged.
(Selectedby Jogkeyandchangedby
+key.)
● SetstheON/OFFdirectionofthe
selectedswitch.
● Whenconditionwasused,thedisplay
canbeswitchedandeachconnection
canbesetbyswitchingthecondition
switch.
ON
ON
ON
ON
OFF
OFF
ON
ON
OFF
ON
ON
OFF
ON ON
OFF
OFF
ON
OFF
ON
OFF
OFF

NULL UP UP&DWN UP&CNT CENTER CNT&DN DOWN
3PositionSwitch
ON
ON
ON
OFF
ON
OFF

NULL UP DOWN
2PositionSwitch
58'ڀ$,/
0,;㌣,1+
5$7(㌣1250
326,㌣'2:1
6:㌣6:$