EasyManua.ls Logo

FUTABA T10J - Trainer Function Operation Modes; Example of Use; Trainer Cords

FUTABA T10J
175 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
93
Commonfunction
Function
6LQFHWKHFKDQQHODQGRSHUDWLRQPRGHXVHGLQWUDLQLQJFDQEHVHOHFWHGWKHWUDLQLQJGLI¿FXOW\FDQEHVHW
to match the student’s level.
The trainer function can be used by connecting the instructors transmitter to the student’s transmitter
XVLQJDVSHFLDOWUDLQHUFRUGVROGVHSDUDWHO\6WXGHQWRSHUDWLRQLVSRVVLEOHE\LQVWUXFWRUVZLWFKRSHUDWLRQ,I
the student enters a dangerous situation, control can be immediately switched to the instructor.
Fouroperationmodescanbeselectedateachchannel.
ThetrainerswitchissettoswitchH.
Whenthetrainerfunctionisused,thesnaprollfunctionisautomatically
deactivated.
Usethetrainerfunctionunderthefollowingconditions:

WhentheinstructorusesaT10Jtransmitter,setthestudentʼ stransmittermodulationtoPPM(for
conventionalfrequencytransmitter).(WhenthestudentusesaT10Jtransmitter,themodulation
modedoesnothavetobechanged.APPMsignalisalwaysoutputfromthetrainerjack.)
Beforeflightalwaysconfirmthatalltheinstructorandstudentchannelsoperatenormallyasset.
Alwaysinsertthetrainercordasfarasitwillgoandtakemeasuressothatthecordwillnotwork
looseduringuse.
Alwaysremovethehighfrequencymoduleofthestudentʼ stransmitter.(Formoduletype)
Neverturnonthestudentʼ stransmitterpowerswitch.
Trainerfunctionoperationmodes
FNCmode:Thechannelsettothismodecanbecontrolledbythestudentusingthemixingsetatthe
instructorʼ stransmitter.(Studentsettingsarereturnedtotheirinitialvalueinadvance.)
MIXmode:Thechannelsettothismodeiscontrolledbymixingtheinstructorandstudentsignals.
Correctionrudderisappliedbytheinstructor.Whenthismodeisselected,thestudentʼ srateis
reducedtopreventservooverthrow.Thestudentʼ sratecanalsobeset.(Thestudentʼ ssettingsare
returnedtotheirinitialvalueinadvance.)
NORmode:Thechannelsettothismodeiscontrolledbysignalsfromthestudentʼ stransmitter.(The
instructorandstudentsettingsmustbethesame.)
OFFmode:Thechannelsettothismodecannotbecontrolledbythestudent.Itcanonlybecontrolled
bytheinstructor.
However,channelsnotprovidedatthestudentʼ stransmitterarecontrolledbytheinstructorregardlessoftheabove
settings.
Whenothermodelsareselected,thetrainerfunctionisdeactivated,butthechannelsettingsremain.
Exampleofuse
WhentheFUNCmodeissetatthestickchannel,helicopterstickoperationtrainingispossibleeven
witha4EXtransmitter(4channelsforaircraft).
Controlbytheinstructorispossiblebysettingonlythetrainingchannelmatchedtothestudentʼ s
leveltotheNORMmodeandsettingtheotherchannelstotheOFFmode.
TRAINER
Trainer
(Common)
Teacher
Trainercode
Student
Instructor Student TrainerCords
10J
10C,9C,7C,6EX,4EX
T12FG(FUTM4405)
18MZ,14MZ,14SG,
FX-22,12Z,12FG,
8FG,10J,8J,6J
T12FG(FUTM4405)and9C
(FUTM4415)TrainerCords
18MZ,14MZ,
14SG,FX-22,12Z,
12FG,8FG,10C,
9C,7C,8J,6J,4EX
10J
TrainerCords
CAUTION

Table of Contents

Other manuals for FUTABA T10J

Related product manuals