FUTABA T10J - Model Transfer

92
Commonfunction
Function
Method
①Callthemenuscreenfromthe
homescreenbypressingthe+key
for1second.
＋
② Select
fromthemenuwiththeJog
key.
③Openthesettingscreenby
pressingtheJogkey.
（1second）
Callingthesettingscreen
Transmission of model data is possible with
T10J transmitters. Data transfer is performed by
the radio. The MDL-TRANS function works with
the current model you are using in the transmitter.
As for the receiving transmitter, any data on the
current model that is receiving the information will
be over-written.
"MDL-TRANS"
MDL-TRANS
Modeltransfer
(Common)
●
MDL-TRANSbetweentwoT10Jradiosshouldbeperformedwithin2-meterrange.
① IneachT10J,the＋ or −keyispressedanditis
made"TRANSFER"and"RECEIVE".
＋ −
or
● "TRANSFER"：T10Jofdataorigin
"RECEIVE"：T10Jwhichreceivesdata
Selectionrange：TRANSFER,RECEIVE
② Select"Execute"withtheJogkey.
③ HolddowntheJogkey[eachT10J].
（1second)
）
● "COMPLETE"isdisplayedandthemode
transferisfinished.
Modeltransfer
● Ifdataisnotbeingtransmitted,thereceivingtransmitter
returnstonormaloperation10secondsafterexecution.At
thistime,"Failure"(nottransmitting)isdisplayed.
● FromT8JtoT10J,datatransferispossible.Inthatcase,TYPE
ofT10Jonthe"RECEIVER"sideischangedinto"T8J"by＋−
key.However,datacannotbesenttoT8JfromT10J.

$OZD\VFKHFNVHUYRGLUHFWLRQSULRUWRHYHU\
IOLJKWDVDQDGGLWLRQDOSUHFDXWLRQWRFRQILUP
SURSHUPRGHOGDWHKRRNXSVDQGUDGLRIXQFWLRQ
NOTE:
MDL-TRANS between two T10J radios should
be performed within a 2-meter range.
CAUTION
0'/75$16
MODE：
TRANSFER（T10J ofdata
origin）／
RECEIVE（T10Jwhich
receivesdata）
Executionoftransmission/
reception
*T10J does not carry out normal operation during data transfer.