FUTABA T10J - TX SETTING - System Configuration; Stick Mode and Calibration

174
TXSETTING
The settings here are special settings that are unnecessary during normal use. The stick mode can be
changed and stick adjustment (calibration), throttle lever reverse, and language can be set.
■ STK-MODE
■ STK-ADJ
Turnonthepowerswitchwiththe+key
and‒keypressedinthepoweroffstate.The
screenshownattheleftappears.Toreturn
tothehomescreen,turnoffthepower
andthenturnthepowerbackonwithout
pressingthekeys.
ThisistheMODE1 〜 MODE4setting.The
initialstateisMODE2.Tochangethemode
thestickratchetmustbechanged.Request
thatthisbedonebyFutabaService.(Charged
modification)
Thisfunctionisnormallynotused.Ifstickdeviationshouldoccur,makethisadjustment.
Donotuseitinthenormalstate.
THRELE
RUD
AIL
MODE1
ELETHR
RUD
AIL
MODE2
THRELE
AIL
RUD
MODE3
ELETHR
AIL
RUD
MODE4
①Turnoffthepowerandthen
turnthepowerbackonwhile
pressingthe+keyand‒key
simultaneously.
②SelectSTK-ADJ → NEXT
inthemenuwiththeJog
key.
③Enterthesettingscreenby
pressingtheJogkey.
Callingthesettingscreen
＋ −
①Selectthestickyouwantto
adjustwith1 〜 4withthe+
key.
＋
②PresstheJogkeydown
andselectNEUT■ .
③Setthesticktotheneutral
positionandpresstheJog
key.
Stickadjustment
23
4
1
7;6(77,1*
(QJOLVKᴾ
67.02'( 
67.$'- 1(;7
7+55(9 125
/$1*8$*(