Concord 4
Installation Manual
98
Output text (10120 to 10123)
Default setting is None.
Entering text for an output allows the user to control it directly or by schedule. Use the following guidelines to
name SnapCard outputs:
• Use the item numbers that appear in Appendix C, Reference tables for characters and words listed
there.
• If you want an output for User Output Control, you must use the output text feature to name the output.
If no output text is programmed, the user will not have access to the output.
• When using words from Appendix C, Reference tables, spaces between them appear automatically.
When using characters from the table to create words, you must reserve an item number for a space
after the word.
• Each character or word uses one item number. For example, a word from the list counts as one item
number.
• Only 16 item numbers are allowed for each output name, so plan ahead before programming output
text. You may need to abbreviate words to avoid running out of item numbers.
To program output text, do the following:
1. With the display showing SNAPCARDS, press #, then A or B until the display shows OUTPUT TEXT.
2. Press # and the display shows OUTPUT 1.
3. Press A or B until the desired output number is displayed.
4. Press # and the display shows OUTPUT N ITEM 0 0 - where ITEM 0 is the first character/word
location and 0 is the character/word number.
5. Enter the number of the desired character or word, or scroll through the numbers by pressing B
(forward) or A (backward). If you make a mistake, enter the correct number or continue scrolling
through choices.
6. Press # to accept the displayed choice and the display shows OUTPUT N ITEM 1 0 -.
7. Repeat the process as needed to complete the output name.
8. Press * after entering the last character or word number. The display shows the complete text name.
For example: OUTPUT 1 GARAGE DOOR.
To Next Page
Loading...
Need help?
General
