Chapter 3
Programming
55
Open/close reports (01004, 01014, and 01024)
Default setting is Off.
This setting determines whether opening and closing reports are sent to the central station. When turned on, the
panel sends a closing report when the system is armed and an opening report when the system is disarmed.
Note: To use this feature, the opening reports and closing reports settings under the Reporting menu on page 73 must be
turned on for that partition.
To turn opening/closing reports off or on, do the following:
1. With the display showing OPEN/CLOSE RPTS OFF/ON (current setting), press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
Backup (01005, 01015, and 01025)
Default setting On for 1 and Off for 2 and 3.
This setting determines whether or not the panel uses another programmed central station phone number for
reporting if attempts with the first number are unsuccessful.
When backup is off, the panel makes up to eight attempts to deliver a report with the programmed phone
number. When backup is set to on, the panel makes up to 16 attempts to deliver the report, alternating between
the programmed phone number and the backup phone number. Central station phone 1 is backed up by central
station phone 2. Central station phones 2 and 3 are backed up by central station phone 1.
To turn backup off or on, do the following:
1. With the display showing BACKUP OFF/ON (current setting), press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
SIA/CID reporting (01006, 01016, and 01026)
Default setting is CID.
This setting determines whether the panel uses the SIA or CID (Contact ID) reporting format for central station
communication. To select SIA or CID reporting, do the following:
1. With the display showing REPORTING FORMAT SIA/CID (current setting), press 1 (SIA) or
2 (CID).
2. The display flashes the entered setting. Press # and the display shows the new setting.
Cellular backup (01007, 01017, and 01027)
Default setting is On for 1 and Off for 2 and 3.
This setting determines whether the panel uses cellular communication for reporting if attempts using a
landline are unsuccessful. To turn cellular backup off or on, do the following:
1. With the display showing CELLULAR BACKUP, press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.