Concord 4
Installation Manual
60
To turn automatic test reset off or on, do the following:
1. With the display showing AUTO TEST RESET OFF/ON (current setting), press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
Comm failure (02003)
Default setting is On.
This setting determines whether the panel activates trouble beeps to alert users on the premises that
communication to the central station failed. Failure notification occurs after the third unsuccessful reporting
attempt to the central station/pager. Failure notification can occur immediately if inadequate phone line voltage
is detected upon the initial dialing attempt.
Note: For UL listed installations, Comm failure must be turned on.
To turn the setting off or on, do the following:
1. With the display showing COMM FAILURE OFF/ON (current setting), press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
DTMF dialing (02004)
Default setting is On.
This setting determines whether the panel uses DTMF tones (on) or pulse (off) for dialing programmed phone
numbers. To turn DTMF dialing off or on, do the following:
1. With the display showing DTMF DIALING OFF/ON (current setting), press 1 (off) or 2 (on).
2. The display flashes the entered setting. Press # and the display shows the new setting.
Dialer abort delay (02006)
Default setting is 30 seconds.
This setting determines how much time the user has to abort a panel alarm report.
Note: For UL listed systems, the combined time for the Entry delay and Dialer abort delay must not exceed 60 seconds.
To change the dial abort delay, do the following:
1. With the display showing DIAL ABORT DELAY nn SECS (current setting), enter the time (15 to 45
seconds).
2. The display flashes the entered setting. Press # and the display shows the new setting,
To Next Page
Loading...
Need help?
General
