GE eBike BASIC - User Manual

GE Healthcare
eBike II / eBike II L / eBike II EL
Service Manual
2018112-069 Revision F

Summary

Mechanical assembly

Control terminal

Details on disassembling and opening the control terminal for access.

Load unit

Information on the assembly and components of the load unit.

LRE board exchange

Steps for removing and replacing the LRE board.

DMS exchange

Procedure for removing and replacing the DMS unit.

Load unit exchange

Steps for removing and replacing the entire load unit.

Service menu

Default settings

Overview of default operational parameters and settings menu.

Static Load Calibration

Procedure for static calibration of the load unit.

Dynamic Load Cal.

Procedure for dynamic load calibration using a test bench.

Software Update

Instructions for updating the ergometer firmware.

NIBP Parameter

Parameter settings for the NIBP module.

Saddle Calibration

Procedure for adjusting the electrical saddle motor.

System Config.

Configuration of hardware modules and options for the ergometer.

Error log

NIBP Test; NIBP Calibration

Procedures for testing and calibrating the NIBP module.

Analog Comparison (calibration)

Aligning analog remote signals with ECG devices.

Alignment Input: Analog Loadcontrol“

Alignment Ouput: Analog Load value“

Alignment Output: Analog Heartrate“

Alignment Ouput: Analog Systole“

Alignment Ouput: Analog Diastole“

Alignment Ouput: RPM“

Alignment Output: ECG“

Alignment; Calibration

Static calibration

Procedure for static calibration using an ergometer lift-up tool.

eBike II basic; comfort

eBike II L

eBike II EL

Preventive Maintenance

Procedures for routine checks and maintenance.

Final checkout procedure; Functional test

Cleaning, Maintenance, Disposal

Maintenance

Technical Safety Inspections and Technical Inspections of the Measuring System

Uncrating and basic assembly instruction eBike II L; EL

GE eBike BASIC Specifications