GE eBike BASIC - Remove Transport Screws

- 222 - eBike II, eBike II L, eBike II EL 2018112-069 Rev. E
eBike II L / EL - uncrating instructions - 217 -
Castors mountinG
• Turn the eBike L / EL 90° on the palett.
The corners of the base frame should overlap on
both sides.
• Screw all 4 double castors into the base frame
using the included Allen key and tighten them
carefully.
• Lift the eBike L / EL at the bottom end, shift it
onto the castors and position it on the oor.
Remove the palett with the cardboard.
- 216 - eBike II L / EL - uncrating instructions
• Cut and remove the tapes xing the 2nd
accessories box.
This box contains:
- 4 double castors with mounting screws
and Allen key
- outrigger (eBike EL only)
- paper rol holder
remove transPort sCrews
• 4 screws are xing the eBike L / EL on the palett.
• Unscrew all 4 screws with a wrench
(17 mm - metric).