GE eBike BASIC - Replace Saddle Motor with BCU

2.
replaCe saddle Motor wItH BCu
Before you can replace the saddle motor, the
connectionbox and the casing must be removed rst.Then
follow these steps to replace the saddle motor:
• Loosen both hexagon socket screws a. of the saddle
guide.
• Remove pin b. with self-locking screw.
• Disconnect plug of cable A at motor control
(connector 2. in illustration).
Open cable tie and pull cable towards the saddlemotor.
Troubleshooting
• Before replacing the saddle motor make sure that
the motor is actually defective.
• For this check, switch the hexagon socket of the
saddlemotor from channel 2 to channel 1.
• If the motor does not work, it is out of order and
must be replaced.
• If the motor works, the motor control unit or the
hand switch is defective.
Note
• To facilitate pulling in the new saddle motor cable,
attach a draw rope to the cable of the old saddle-
motor)
• When mounting the new saddle motor, secure the
motor control connection cable with a cable tie d, as
shown in the illustration.
- 110 - eBike II, eBike II L, eBike II EL 2018112-069 Rev. F