GE eBike BASIC - Page 180

- 180 - eBike II, eBike II L, eBike II EL 2018112-069 Rev. F
2018111-104
1x clamping sleeve for handgrip tube, complete
2x star washer 5.3
1x screw M5x6
1x Novo Grip clamping lever M10x15
SPARE EBIKE L&EL CLMPG LVR SET HANDGRIP
Service Kit: Clamping lever kit for handgrip tube
2018111-194
1x clamping plate 30x8x34
1x reinforcing angle 34.3x25x2
1x star knob M10x15
SPARE EBIKE II L&EL CLAMPING LEVER SET
Service Kit: Clamping lever kit for eBike L/EL
2018111-219
1x motor, lateral tilt (motor max. 10°) for eBike EL
2x stud screw SW19
2x washer U24
2x washer U13
4x ring Hostaform D. 30
2x nut M12, self-locking
3x cable tie 95 mm
SPARE EBIKE EL MOTOR TRANSVERSE ANGLE SCU
Service Kit: Motor l laterral tilt for eBike EL
2018111-220
eBike EL motor controler firmware instruction installation
Label eBike EL motor controler firmware version
EBIKE EL MOTOR CONTROLER FIRMWARE UPGRADE KIT
Firmware Upgrade Kit: Motor Controler for eBike EL
GE Healthcare
Instruction
eBike EL
Motor Controller Firmware Installation
2018111-341 A
17 March 2017
Introduction
The eBike EL Motor Controller Firmware Update is intended for GE Healthcare Field
Engineers.
The purpose of this manual is to update the rmware in the eBike EL Motor Controller
from revision 11 to 12.
Affected eBike
Motor controller rmware on eBike EL V2 type SKF Actuation System
Affected Part Numbers
Description
2018111-213 SPARE EBIKE EL MOTOR CONTROLLER 240V
2018111-214 SPARE EBIKE EL MOTOR CONTROLLER 120V
Required Equipment
The following equipment is required for the update:
• Firmware upgrade kit
Includes this instruction document and revision label.
• Laptop or personal computer running Microsoft Windows 7 or 8.1 OS
NOTE:
The term “P C” is used throughout this document to indicate laptop or personal
computer.
GE Medical Systems Information Technologies, Inc., a General Electric
Company, going to market as GE Healthcare.
8200 West Tower Avenue Milwaukee, WI 53223 U.S.A.
© 2017 General Electric Company.
All Rights Reserved.