GE HEALTHCARE
DIRECTION 2286865, REVISION 14 LOGIQ™ 7 SERVICE MANUAL
Section 6-5 - Monitor and LCD Adjustments 6-17
6-5-5-1 For Gaudi LCD (cont’d)
11.)After finishing the Auto Adjustment procedures, the following menu is displayed on the LCD.
12.)Make sure that the LCD position is fixed and shown at the center location.
13.)If it is fixed appropriately, select OK then touch ENTER to go on to the next step.
If the display is not adjusted yet, select CANCEL then touch ENTER to repeat the adjustment
procedures form step 6.
14.)The first screen is shown on the display. Touch SELECT three times to select EXIT. Refer to Figure
6-19.
15.)Touch ENTER button. OSD menu will be finished, and go back to regular display.
Figure 6-20 OSD Softment 2
10A5V1.0
FINISHED
OK
CANCEL
SELECT ENTER
To Next Page
Loading...
Need help?
General
