GE HEALTHCARE
DIRECTION 2286865, REVISION 14 LOGIQ™ 7 SERVICE MANUAL
8-42 Section 8-2 - Software Loading Procedures for BT09 (R8.x.x or later)
8-2-10-7 Regional Setup (For the system with language other than English ONLY) (cont’d)
8.) Select the Language tab, press Details, under Installed Services select the Japanese keyboard,
under Default input language select Japanese, press Apply, Press OK.
9.) Select the Advanced tab, then select Japanese in the Language for non-Unicode programs pull-
down menu. Press Apply. Answer Yes to use files already loaded on the hard disk, then answer
No to not reboot the system yet, press OK. Press Save and Exit the Utility screen.
10.)Reboot the system.
11.)In Utility--> System--> General, press Regional Options. Select Language Tab and press
Details. Remove English under Installed Services and press Apply and OK.
12.)Select Utility--> System--> About-->Additional Info menu.
Figure 8-103 Language tab
NOTICE
To have the settings take effect, you MUST turn off the system and turn it back on.
To Next Page
Loading...
Need help?
General
