GE HEALTHCARE
DIRECTION 2286865, REVISION 14 LOGIQ™ 7 SERVICE MANUAL
Section 8-2 - Software Loading Procedures for BT09 (R8.x.x or later) 8-41
8-2-10-7 Regional Setup (For the system with language other than English ONLY) (cont’d)
6.) In Utility> System> General, set the Language as JPN. Save this setting, but do not reboot the
system yet.
7.) Press Regional Options, under Standards and Formats select Japanese, under Location select
Japan. Press Apply.
Figure 8-101 General
Figure 8-102 Regional Options
To Next Page
Loading...
