GE HEALTHCARE
DIRECTION 2286865, REVISION 14 LOGIQ™ 7 SERVICE MANUAL
4-12 Section 4-2 - General Procedure
4-2-6-2 Using Regional Preset
Regional Preset is selected during Application Load (Refer to 8-8-13 - Installing R7.x.x Application
Software for details).
Current Regional Preset is displayed under Utility > System > About .
Factory Default Regional Preset can be re-loaded from Utility > Systme > About > Additional About.
Figure 4-14 Current Regional Preset
NOTICE
For Upgraded BT07, this field always shows "None" as Region Preset is feature available for pure BT07
and onward.
Figure 4-15 Factory Default Regional Preset
To Next Page
Loading...
