GE LOGIQ 7

GE HEALTHCARE
DIRECTION 2286865, REVISION 14 LOGIQ™ 7 SERVICE MANUAL
Section 4-1 - Overview 4-1
Chapter 4
Functional Checks
Section 4-1
Overview
4-1-1 Purpose for Chapter 4
This chapter provides procedures for quickly checking major functions of the LOGIQ™ 7 console,
diagnostics by using the built-in service software, and power supply adjustments.
4-1-2 Special Equipment Required
• An empty (blank) MO Disk.
• At least one transducer.
(normally you should check all the transducers used on the system.)
Table 4-1 Contents in chapter 4
Section Description Page Number
4-1
Overview
4-1
4-2
General Procedure
4-2
4-3
Functional Checks
4-20
4-4
Application Turnover Check List
4-27
4-5
Diagnostics
4-28
4-6
Power Supply
4-29
4-7
Site Log
4-30
NOTICE
Most of the information pertaining to this Functional Checks chapter is found in the LOGIQ™ 7 Quick
Guide (Direction Number 2291859-100).
Look for the letters (QG) after a section in the Table of Contents to determine if the information is in this
chapter or in the Quick Guide.