GE Simon 60-875 - Option 11: Exit Delay; Option 12: Phone 1 Reports; Option 13: Phone 2 Reports

Simon Security System 27
Option 11: Exit Delay
(Default = 060 sec.)
Determines how much time the user has to leave the pre-
mises through a designated delay door after arming the sys-
tem. Beeps sound after arming the system to remind the user
to leave the armed premises.
If a delay door is opened after the Exit Delay expires, the
Entry Delay begins. If the user arms the system with No
Delay and opens a delay door after the Exit Delay expires, an
alarm occurs.
When turned on, the Exit Delay can be set from 005-254 sec-
onds (045-254 if SIA Limits Option 69 is on). All entries
must be 3 digits. When turned off, the Exit Delay is set to
005 seconds.
Note
For UL listed systems, the exit delay must not exceed 60 sec-
onds.
¾ To set Exit Delay, press:
1. Add
2. Option #
3. 11
4. Use the numbered keys to enter the 3-digit delay
time.
5. DONE
¾
To turn off Exit Delay, press:
1. Delete
2. Option #
3. 11
4. DONE
Option 12: Phone 1 Reports
(Default = 00)
Determines the primary phone number (Option 4) report con-
tent and reporting format. All entries must be 2 digits.
Note
UL has only verified reporting compatibility with the CS5000 Digi-
tal Alarm Communicator Receiver. For UL listed systems, Phone
1 Reports must be set to 0 or 1.
The Phone 1 & 2 Reports table below describes the choices.
Alarms include: Fire, Intrusion, Emergency, Silent, and
Alarm Cancels.
Non-alarms include: Latchkey, No Activity, Openings, Clos-
ings, Fail to Open, Fail to Close, Force Armed, AC Power
Failure, CPU Low Battery, and Trouble Restorals.
Note
This option must be turned off if using a DTIM to transmit on the
regular phone line.
¾ To set Phone 1 Reports, press:
1. Add
2. Option #
3. 12
4. Use the numbered keys to enter 00 - 10 (see table
below).
5. DONE
¾
To turn off Phone 1 Reports, press:
1. Delete
2. Option #
3. 12
4. DONE
Option 13: Phone 2 Reports
(Default = off)
Determines the secondary phone number
(Option 5) report content and reporting for-
mat. The Phone 1 & 2 Reports table below
describes the choices. All entries must be 2
digits.
Note
This option must be turned off if using a DTIM to
transmit on the regular phone line.
¾ To set Phone 2 Reports, press:
1. Add
2. Option #
3. 13
4. Use the numbered keys to enter 00 - 10 (see table below).
5. DONE
¾
To turn off Phone 2 Reports (return to default), press:
1. Delete
2. Option #
3. 13
4. DONE