Simon Security System
28
Phone 1 & 2 Reports
Setting # Content Format
Off None None
00 All SIA
01 All Contact ID
02 Alarms only SIA
03 Alarms only Contact ID
04 Non-Alarms only SIA
05 Non-Alarms only Contact ID
06 Phone Failure (backup) SIA
07 Phone Failure (backup) Contact ID
08 Latchkey, No Activity, Phone Test, Openings, Closings,
Fail to Open/Close, AC Power Restorals/Failures
Pager
09 Same as setting 8 plus Alarms Pager
10 Alarms and Latchkey only (See Options 43 and 44 for
more details.)
Voice Event
Notification
Option 14: DTMF Dialing
(Default = on)
Determines whether the panel uses DTMF (on) or pulse (off)
for dialing programmed phone numbers.
¾
To turn on DTMF Dialing, press:
1. Add
2. Option #
3. 14
4. DONE
¾
To turn off DTMF Dialing, press:
1. Delete
2. Option #
3. 14
4. DONE
Option 15: No Activity Timeout
(Default = off)
Determines whether the panel sends a No Activity report to a
central station or pager when the programmed time period
elapses (on), or if the feature is disabled (off).
No activity means control panel, remote handheld, and key-
chain touchpad buttons have not been pressed and sensors
have not been tripped within a specified period of time
(except sensors in group 25).
The timeout can be set from 02 - 24 hours. All entries must
be 2 digits.
¾
To set No Activity Time-out, press:
1. Add
2. Option #
3. 15
4. Use the numbered keys to enter a time 02 - 24 (all
entries must be 2 digits).
5. DONE
¾
To turn off No Activity Time-out, press:
1. Delete
2. Option #
3. 15
4. DONE
To Next Page
Loading...
