GE Simon 60-875 - Option 50: RF Jam Detect; Option 51: 24 Hour Sensor Tamper; Option 52: Unvacated Premises

Simon Security System
42
Option 50: RF Jam Detect
(Default = off)
Determines whether the panel checks for and reports RF
interference/jam to the central station (on), or not (off).
If this option is on and the panel receives a constant
319.5 MHz signal, the panel speaker announces “RF
Failure” and reports the condition to the central station.
Touchpads will announce “Option 50 Detected”. If this
option is off, the panel does not detect an RF jam.
Note
For UL listed systems, RF Jam Detect must be on.
¾To turn on RF Jam Detect, press:
1. Add
2. Option #
3. 50
4. DONE
¾
To turn off RF Jam Detect, press:
1. Delete
2. Option #
3. 50
4. DONE
Option 51: 24 Hour Sensor Tamper
(Default = off)
Determines whether the system (armed or disarmed)
goes into and reports an alarm anytime a sensor tamper
switch is tripped (on), or only when the system is
armed and a tamper switch of an armed sensor is
tripped (off).
¾
To turn on 24 Hour Tamper, press:
1. Add
2. Option #
3. 51
4. DONE
¾
To turn off 24 Hour Tamper, press:
1. Delete
2. Option #
3. 51
4. DONE
Option 52: Unvacated Premises
(Default = on)
Determines whether the system automatically arms
down to level 2 (ARM Doors & Windows) if the user
arms the system to level 4 (ARM Doors & Windows, +
ARM Motion Sensors) without leaving the premises
(on), or remains at the armed level chosen by the user
(off).
Note
If Options 81 and 82 are programmed, the RF Thermostat
will change from Energy Saving Mode to normal operating
mode when the panel is armed to level 2.
This feature does not work from a keychain touchpad.
Option 38: Auto Arm must be on for this feature to work.
¾To turn on Unvacated Premises, press:
1. Add
2. Option #
3. 52
4. DONE
¾
To turn off Unvacated Premises, press:
1. Delete
2. Option #
3. 52
4. DONE