Simon Security System
48
Option 67: Quick Exit
(Default = off)
Determines whether pressing the Disarm button when
the system is armed activates the exit delay time to
allow exit and re-entry without disarming the system
(on) or not (off).
This feature is useful if the user wants to step outside
briefly and return, such as to get the paper. If the sys-
tem is armed and the user presses the Disarm button,
the panel announces “Exit time on” and sounds exit
delay beeps. This allows a designated entry/exit door
to be open for up to 2 minutes without causing an
alarm. When the door is closed, the beeps stop and the
door is armed again.
Note
For UL listed systems, Quick Exit must be off.
¾To turn on Quick Exit, press:
1. Add
2. Option #
3. 67
4. DONE
¾
To turn off Quick Exit, press:
1. Delete
2. Option #
3. 67
4. DONE
Option 68: Swinger Shutdown
(Default = on)
Determines whether the panel prevents the same sensor
from activating an alarm more than once in a single
arming period (on) or not (off).
Note
Swinger Shutdown does not affect smoke and fire sensors.
¾To turn on Swinger Shutdown, press:
1. Add
2. Option #
3. 68
4. DONE
¾
To turn off Swinger Shutdown, press:
1. Delete
2. Option #
3. 68
4. DONE
Option 69: SIA Limits
(Default = on)
Determines whether Entry, Exit, and Dialer delay times
fall within SIA limits (on) or factory ranges (off).
The table below shows the available settings when this
option is on or off.
Note
If options 10, 11 or 17 are set outside the SIA limits while
Option 69 is OFF, turning Option 69 ON will not affect
options 10, 11 or 17 until they are manually changed.
Not investigated for use by UL.
Note
When this option is off, there are no CS reports for sensor
tests.
¾To turn on SIA Limits, press:
1. Add
2. Option #
3. 69
4. DONE
¾
To turn off SIA Limits, press:
1. Delete
2. Option #
3. 69
4. DONE
SIA Limits
Affected Option
SIA Limits
(Option 69 on)
Factory Ranges
(Option 69 off)
Option 10: Entry Delay 030-254 seconds 005-254 seconds
To Next Page
Loading...
