GE Simon 60-875 - Option 79: Panel Cover Tamper; Option 80: Alarm Report Verification; Option 81: Heating Set Point

Simon Security System
52
Option 79: Panel Cover Tamper
(Default = off)
Determines whether the panel activates a
tamper alarm anytime the cover is opened
(on), or only when the system is armed (off).
To enter program mode when this option is
on, you must first enter the Master Access
code, then open the cover and enter program
mode within 10 seconds.
¾
To turn on Panel Cover Tamper, press:
1. Add
2. Option #
3. 79
4. DONE
¾
To turn off Panel Cover Tamper (return to default), press:
1. Delete
2. Option #
3. 79
4. DONE
Option 80: Alarm Report Verification
(Default = off)
Determines whether the panel verifies success-
ful alarm reports to the central station/pager
with the voice message “Phone communication
okay” (on), or not (off).
¾
To turn on Alarm Report Verification, press:
1. Add
2. Option #
3. 80
4. DONE
¾
To turn off Alarm Report Verification (return to default),
press:
1. Delete
2. Option #
3. 80
4. DONE
Option 81: Heating Set Point
(Default = off)
If the room temperature falls below the Heat-
ing Set Point, the RF Electronic Thermostat
will turn the furnace on until the room temper-
ature returns to the Heating Set Point.
The Heating Set Point can be set between 51°F
and 91°F
See the Dialog RF Electronic Thermostat
Instructions (466-1931) for more information
on its use.
¾
To adjust Heating Set Point, press:
1. Add
2. Option #
3. 81
4. Use the numbered keys to enter 51 - 91.
5. DONE
¾
To turn off Heating Set Point (return to default), press:
1. Delete
2. Option #
3. 81
4. DONE