GE Simon 60-875 - Adding (Learning) Sensors

Simon Security System
18
Adding (Learning) Sensors
These instructions describe how to add sensors, touchpads and other system devices
into panel memory. The panel recognizes a sensor when you press a sensor program
button, press and release a tamper switch, press a sensor test button, or put a sensor into
alarm.
Note
The hardwire inputs must have sirens or hardwire sensors with 47k Ohm resistors connected
between the DCOUT and HWIN1 or HWIN2 terminals before learning in a sensor. If one of
these connections is not made, the panel will learn in a hardwire zone.
Note
If you are installing a sensor on a gun case, jewelry box, or similar usage, and the sensor is
active in level one, you must sub-disarm to avoid putting the panel into alarm when the sensor
and the magnet are separated.
The following table, “Device Programming,” describes the programming button loca-
tion for each device.
Device Programming
Device To Program
Door/Window Sensor Press button on top of sensor (cover removed)
or trip tamper
Motion Sensor Press button on back of sensor (mounting plate
removed) or trip tamper
Smoke Sensor Trip tamper, press test button, remove from
base or put sensor in alarm
Keychain Touchpad Press and hold Lock & Unlock buttons together
ELM Keychain Touchpad
Remote Handheld Touchpad Press the EMERGENCY buttons
QS1500 Keypad Press Lights Off button 6 times
Hardwire Sensors Separate sensor from magnet
CO Alarm Plug in the module wait 5-7 seconds press and
hold the test button for 9 beeps
Freeze & Water Trip tamper or press and hold button on top of
the sensor (cover removed) until control panel
confirms programming. If button is not held
down long enough, SYSTEM STATUS reports
sensor as open.
Dialog RF Electronic Thermostat Unplug the thermostat from the base plate, wait
a few seconds, then plug the thermostat back
into the base plate.
Personal Help Button Press the help button until the light blinks.
Press
Hold
Hold
Flash
Flash
Flash
Hold until LED is done flashing.
Wait 2 seconds for each flash
Press
Press
Hold Flash Flash Flash