GE Simon 60-875 - Option 90: Comm Channel 1 Reports; Option 91: Comm Channel 2 Reports; Option 92: Comm Channel 3 Reports

Simon Security System 55
Option 90: Comm Channel 1 Reports
(Default = off)
The setting for this option determines which
reports are sent to central station receiver 1 by
the Ethernet Interface module.
• Off = no reports
• 0 = all event reports
• 1 = alarms and manual comm test
Note
When this option is on, only SIA accounts will
report phone communication failures to pre-
misesconnect.com.
¾To set Comm Channel 1 Reports, press:
1. Add
2. Option #
3. 90
4. Use the numbered keys to enter 0 or 1.
5. DONE
¾
To turn off Comm Channel 1 Reports (return to default),
press:
1. Delete
2. Option #
3. 90
4. DONE
Option 91: Comm Channel 2 Reports
(Default = off)
The setting for this option determines which
reports are sent to central station receiver 2 by
the Ethernet Interface module.
• Off = no reports
• 0 = all event reports
• 1 = alarms and manual comm test
Note
When this option is on, only SIA accounts will report
phone communication failures to premisescon-
nect.com.
¾To set Comm Channel 2 Reports, press:
1. Add
2. Option #
3. 91
4. Use the numbered keys to enter 0 or 1.
5. DONE
¾
To turn off Comm Channel 2 Reports (return to default),
press:
1. Delete
2. Option #
3. 91
4. DONE
Option 92: Comm Channel 3 Reports
(Default = off)
The setting for this option determines which
reports are sent to premisesconnect.com by the
Ethernet Interface module.
• Off = no reports
• 0 = all event reports
Note
When this option is on, only SIA accounts will report
phone communication failures to premisescon-
nect.com.
¾To set Comm Channel 3 Reports, press:
1. Add
2. Option #
3. 92
4. Use the numbered keys to enter 0.
5. DONE
¾
To turn off Comm Channel 3 Reports (return to default),
press:
1. Delete
2. Option #
3. 92
4. DONE