Simon Security System
64
2-Way Voice Operation
Note
Panel voice announce-
ments are silenced during
AVM sessions. If the opera-
tor does not terminate the
session correctly, panel
announcements may not
occur for up to 90 seconds
after the operator hangs up.
To initiate an audio session, the central station operator must perform the following
steps:
1. After the panel has completed reporting the alarm, pick up the CS phone and press
the
‚ button to start the audio session.
2. Press 1 or 0 to speak, 2 for VOX operation, and 3 or 6 to listen.
3. Press 99 to terminate the session.
Note
To conduct an audio session
using remote phone access
see the Table “Phone Com-
mands for Remote Access”
in the “Testing” section.
Emergency -107 -107
Intrusion -108 -108
Fire -109 -109
Openings -110 -110
Closings -111 -111
Fail to Open -112 -112
Fail to Close -113 -113
Bypass -114-114
Restoral -115-115
Supervisory -116-116
Trouble -117-117
Tamper -118-118
Gas -119-119
Freeze -120-120
Environmental -121-121
Programming/Sensor Test -122-122
Pager Reporting Message
Reports Numeric Message
Audio Verification Set
Phone Button(s) Function
0-1 Speak
2 VOX operation
3 or 6 Listen
7 Extend session for 90 more seconds
88 Terminates session with call back (the panel answers on the
first ring if called within 5 minutes)
99 Terminates session with no call back
To Next Page
Loading...
