GE Simon 60-875 - X10 Module Operation

Simon Security System
20
¾To delete sensors:
1. Press Delete. The panel announces “Select from Main Menu.”
2. Press Sensor/Remote repeatedly until you hear the name and number you want
deleted, then press DONE. The panel announces that the sensor is deleted.
X10 Module Operation
Use the following procedure to program X10 module operations into panel memory.
Notice that the Light Control button is used to program all X10 module operations
(light, appliance, and universal).
¾
To program the house code:
1. Press Add.
2. Press Light Control repeatedly until you hear the desired house code letter.
3. Press DONE.
4. Set the HOUSE dial on each lamp, appliance, and universal module, to the same
letter.
5. Set the HOUSE dial on powerhorn/remote sirens to the next sequential alphabetical
letter.
¾
To add an entry/exit activated module:
1. Press ADD.
2. Press Light Control.
3. Press Unit # repeatedly until you hear the unit number that matches the one you
chose for the module.
4. Press Entry/Exit Delay. The panel confirms your programming.
¾
To add a sensor-activated module:
Note
A Keychain Touchpad button
can also be programmed to
control a light or appliance
module.
1. Press ADD.
2. Press Light Control.
3. Press Unit # repeatedly until you hear the unit number that matches the one you
chose for the module.
4. Press Sensors until you hear the sensor you want to control the light.
32
978
10
645
Test
System should be checked
422-2806 Rev A
Set
Code
Access Clock
+
Delete
Delete
press
-
+
Hours
at least every three years.
To delete an option or access code
Hold key or press
and follow the voice
repeatedly until you
hear the desired item.
Note:
Cancel
and
Test
Cancel
DONE
Minutes
, then
DONE
See Note
If you make a mistake or want to
Sensor or Phone Test
follow the voice prompting.
To select a test, press
start over press
prompting.
by a qualified technician
Delete
START MENU
Add
Version 3
MAIN MENU
*
Remote
Sensor/
**
Control
Light
Option #
**
Sensors
-
*
Entry/Exit
Delay
CONTROL MENU
*
Press for program
information.
Instruction
Add Option
Summary
Unit #
Add
Press
Clock Set
Press
Set Clock
DONE
Chime Voice
Latchkey Time
Panel Voice
Add Option #
Press
Option #42:
Option #43:
Option #55:
Option #41:
Option #2:
Option #3:
Option #36:
Option #37:
See Note
Sensor Activated Light Lockout Start Time
Sensor Activated Light Lockout Stop Time
and follow voice prompts.
Pager Phone Number
Speaker Volume
Status Beep Volume
Option #1: Panel Beeps
use red numbers to enter 4-digit code.
Add Access Code
Hours
Access Code
See Note
Minutes
Time
Cancel