Genesis G70 User Manual

5
5-39
6.Your Two-Way Communication
programming is now complete.
Information
If your garage door opener has Two-Way
Communication functionality, it is
possible for HomeLink to stop functioning
the garage door shortly after initial
programming, IF the Two-Way
Communication Programming wasn't
properly completed. This usually happens
after the first 10 times a programmed
HomeLink button is pressed. If you
experience this, completing the
"Programming a New HomeLink Button"
and "Two-Way Communication
Programming" will restore door
operation.
4) Canadian Programming
Canadian radio-frequency laws require
transmitter remote signals to "time-out"
(or quit) after a couple seconds of
transmission, which may not be long
enough for HomeLink to pick up the
signal during programming.
If you live in Canada or you are having
difficulties programming a gate operator
or garage door opener by using the
programming procedures, replace
"Programming a New HomeLink Button"
step 3 with the following:
While the HomeLink indicator light (7) is
flashing orange, press and release
("cycle") your device's handheld remote
every two seconds until the HomeLink
indicator light (7) changes from orange to
green. You may now release the handheld
remote button. Then proceed with
"Programming a New HomeLink Button"
step 4.
2. Operating HomeLink®
1) Operating HomeLink®
OIK053372N
1. Press and release the desired
programmed HomeLink button (1, 2 or
3).
Information
The HomeLink indicator (7) should light
green, solid or flashing, and your
programmed device should operate.
If your device does not operate, the
HomeLink programming was not
successful, and you'll need to reprogram
the button.
2) Two-Way Communication Display
Behavior
OIK053373N
1. Press and release one of the
programmed HomeLink buttons (1, 2 or
3).
0_IK_PE_en_US.book Page 39

Genesis G70 Specifications

General

Brand	Genesis
Model	G70
Category	Automobile
Language	English