8
8-23
4. Unscrew the valve cap from the valve of
the defective wheel and screw the
filling hose (3) of the sealant bottle onto
the valve.
OIK083011
Securely install the sealant filling hose
to the valve. If not, sealant may flow
backward, possibly clogging the filling
hose.
5. Plug the compressor power cord (4)
into the vehicle power outlet.
OIK083012
Only use the front passenger side
power outlet when connecting the
power cord.
6.With the engine ON, switch on the
compressor and let it run for about 5-7
minutes to fill the sealant up to proper
pressure. (refer to the "Tires And
Wheels" section in chapter 2). The
inflation pressure of the tire after filling
is unimportant and will be
checked/corrected later.
Be careful not to overinflate the tire and
stay away from the tire when filling it.
Tire pressure
Do not attempt to drive your vehicle if
the tire pressure is below 29 psi (200
kPa). This could result in an accident
due to sudden tire failure.
7. Switch off the compressor.
8.Detach the hoses from the sealant
bottle connector and from the tire
valve.
Return the Tire Mobility Kit to its
storage location in the vehicle.
Carbon monoxide
Do not leave your vehicle running in a
poorly ventilated area for extended
periods of time. Carbon monoxide
poisoning and suffocation can occur.
0_IK_PE_en_US.book Page 23
To Next Page
Loading...
Need help?
General
