8-24
Emergency situations
9.Immediately drive about 4-6 mi. (7-10
km or about 10 minutes) to evenly
distribute the sealant in the tire.
OIK083038
Do not exceed a speed of 50 mph (80
km/h). If possible, do not fall below a
speed of 12 mph (20 km/h).
While driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed and drive with
caution until you can safely pull off of
the vehicle on the side of the road.
Call for road side service or towing.
10.After driving about 4-6 mi. (7-10 km or
about 10 minutes), stop at a safety
location.
11.Connect the filling hose (3) of the
compressor directly to the tire valve.
OIK083043
12.Plug the compressor power cord into
the vehicle power outlet.
13.Adjust the tire inflation pressure to the
recommended tire inflation.
With the engine running, proceed as
follows.
• To increase the inflation pressure:
Switch on the compressor. To check
the current inflation pressure setting,
briefly switch off the compressor.
• To reduce the inflation pressure:
Press the button (9) on the
compressor.
Do not let the compressor run for more
than 10 minutes, otherwise the device will
overheat and may be damaged.
The pressure gauge may show higher
than actual reading when the compressor
is running. To get an accurate tire reading,
the compressor needs to be turned off.
• If the inflation pressure is not
maintained, drive the vehicle a second
time, refer to the step 9. Then repeat
step 10-13.
• Use of the TMK may be ineffectual for
tire damage larger than about 0.16
inches (4 mm).
Have you contact an authorized retailer of
Genesis Branded products if the tire
cannot be made roadworthy with the Tire
Mobility Kit.
0_IK_PE_en_US.book Page 24
To Next Page
Loading...
Need help?
General
