3
3-31
OIK033061
LATCH anchors have been provided in the
left and right outboard rear seating
positions. Their locations are shown in the
illustration. There are no LATCH anchors
provided for the center rear seating
position.
Do not attempt to install a Child Restraint
System using LATCH anchors in the rear
center seating position. There are no
LATCH anchors provided for this seat.
Using the outboard seat anchors can
damage the anchors which may break or
fail in a collision resulting in serious injury
or death.
OIK033062
[A] Lower Anchorage Position Indicator
[B] Lower Anchorage
The lower anchor position indicator
symbols are located on the left and right
rear seat backs to identify the position of
the lower anchors in your vehicle (see
arrows in illustration).
The LATCH anchors are located between
the seatback and the seat cushion of the
rear seat left and right outboard seating
positions.
Before installing the Child Restraint
System, make sure that there are no
objects (for example, toy, pen, wire)
around the lower anchor area. Those
objects may damage either the seat belt
system or the Child Restraint System
during the installment procedure. If
necessary, have your vehicle inspected
by an authorized retailer of Genesis
Branded products.
Securing a Child Restraint System
with the "LATCH Anchors System"
To install a LATCH-compatible Child
Restraint System in either of the rear
outboard seating positions:
1. Move the seat belt buckle away from
the lower anchors.
2. Move any other objects away from the
anchors that could prevent a secure
connection between the Child Restraint
System and the lower anchors.
3. Place the Child Restraint System on the
vehicle seat, then attach the seat to the
lower anchors according to the
instructions provided by the Child
Restraint System manufacturer.
4. Follow the instructions of the Child
Restraint System's manufacturer for
proper installation and connection of
the lower attachments on the Child
Restraint System to the lower anchors.
0_IK_PE_en_US.book Page 31