3-32
Safety system
Take the following precautions when
using the LATCH system:
• Read and follow all installation
instructions provided with your Child
Restraint System.
• To prevent the child from reaching and
taking hold of unretracted seat belts,
buckle all unused rear seat belts and
retract the seat belt webbing behind
the child. Children can be strangled if a
shoulder belt becomes wrapped
around their neck and the seat belt
tightens.
• NEVER attach more than one Child
Restraint System to a single anchor.
This could cause the anchor or
attachment to come loose or break.
• Always have the LATCH system
inspected by your authorized retailer of
Genesis Branded products after an
accident. An accident can damage the
LATCH system and may not properly
secure the Child Restraint System.
The recommended weight for the LATCH
system is under 65 lb. (30 kg).
How to determine an appropriate child
restraint weight: Child weight + Child
restraint weight < 65 lb. (30kg)
Securing a Child Restraint System
seat with "Top-tether Anchorage"
system
OIK033019AU
First secure the child restraint with the
LATCH lower anchors or the seat belt. If
the child restraint manufacturer
recommends that the top tether strap be
attached, attach and tighten the top
tether strap to the top tether strap
anchor.
Child restraint hook holders are located
on the rear of the seatbacks.
OIK033060
To install the tether anchor:
1. Route the Child Restraint System
top-tether strap over the seatback.
Route the tether strap under the head
restraint and between the head
restraint posts, or route the tether strap
over the top of the vehicle seatback.
Make sure the strap is not twisted.
2. Connect the tether strap hook to the
tether anchor, then tighten the
top-tether strap according to the
instructions of your Child Restraint
System's manufacturer to firmly attach
the Child Restraint System to the seat.
0_IK_PE_en_US.book Page 32
To Next Page
Loading...
Need help?
General
