EasyManuals Logo

GeoMax Zoom20 Pro Series User Manual

GeoMax Zoom20 Pro Series
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Safety Directions Zoom20/30/35 Pro | 13
1.7 Electromagnetic Compatibility EMC
Description The term Electromagnetic Compatibility is taken to mean the capability of the product to function smoothly
in an environment where electromagnetic radiation and electrostatic discharges are present, and without
causing electromagnetic disturbances to other equipment.
WARNING
Electromagnetic radiation can cause disturbances in other equipment.
Although the product meets the strict regulations and standards which are in force in this respect, GeoMax
cannot completely exclude the possibility that other equipment may be disturbed.
CAUTION
There is a risk that disturbances may be caused in other equipment if the product is used with accessories
from other manufacturers, for example field computers, personal computers or other electronic equip-
ment, non-standard cables or external batteries.
Precautions:
Use only the equipment and accessories recommended by GeoMax. When combined with the product, they
meet the strict requirements stipulated by the guidelines and standards. When using computers or other
electronic equipment, pay attention to the information about electromagnetic compatibility provided by
the manufacturer.
CAUTION
Disturbances caused by electromagnetic radiation can result in erroneous measurements.
Although the product meets the strict regulations and standards which are in force in this respect, GeoMax
cannot completely exclude the possibility that the product may be disturbed by intense electromagnetic
radiation, for example, near radio transmitters, two-way radios or diesel generators.
Precautions:
Check the plausibility of results obtained under these conditions.
CAUTION
If the product is operated with connecting cables attached at only one of their two ends, for example
external supply cables, interface cables, the permitted level of electromagnetic radiation may be exceeded
and the correct functioning of other products may be impaired.
Precautions:
While the product is in use, connecting cables, for example product to external battery, product to
computer, must be connected at both ends.
Bluetooth Use of product with Bluetooth:
WARNING
Electromagnetic radiation can cause disturbances in other equipment, in installations, in medical devices,
for example pacemakers or hearing aids and in aircraft. It can also affect humans and animals.
Precautions:
Although the product meets in combination with radio or digital cellular phone devices recommended by
GeoMax the strict regulations and standards which are in force in this respect, GeoMax cannot completely
exclude the possibility that other equipment may be disturbed or that humans or animals may be affected.
Do not operate the product with radio or digital cellular phone devices in the vicinity of filling stations
or chemical installations, or in other areas where an explosion hazard exists.
Do not operate the product with radio or digital cellular phone devices near to medical equipment.
Do not operate the product with radio or digital cellular phone devices in aircraft.
1.8 FCC Statement, Applicable in U.S.
Applicability The greyed paragraph below is only applicable for Zoom20/ Zoom20 Pro instruments.
WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

Table of Contents

Other manuals for GeoMax Zoom20 Pro Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GeoMax Zoom20 Pro Series and is the answer not in the manual?

GeoMax Zoom20 Pro Series Specifications

General IconGeneral
BrandGeoMax
ModelZoom20 Pro Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals