GeoMax Zoom20 Pro Series - 5 Settings; General Settings

Zoom20/30/35 Pro | 26Settings
5 Settings
5.1 General Settings
Access 1) Select Settings from the MAIN MENU.
2) Select General from the Settings menu.
3) Press to scroll through the screens of available settings.
GENERAL SETTINGS
Field Description
Tilt Corr. Off Tilting compensation deactivated.
On Vertical angles refer to the plummet line and the horizontal
directions are corrected by the standing axis tilt.
For corrections depending on the HA Corr: setting, refer to the
table "Tilt and horizontal corrections".

If the instrument is used on an unstable base, for example a shaking platform or ship,
the compensator should be deactivated. This avoids the compensator drifting out of
it's measuring range and interrupting the measuring process by indicating an error.
H.A. Corr. On Horizontal corrections are activated. For normal operation the
horizontal correction should remain active. Each measured hori-
zontal angle will be corrected, depending on the vertical angle.
For corrections depending on the Tilt Corr: setting, refer to the
table "Tilt and horizontal corrections".
Off Horizontal corrections are deactivated.
H.A. Incr. Right Set horizontal angle to clockwise direction measurement.
Left Set horizontal angle to counter-clockwise direction measure-
ment. Counter-clockwise directions are displayed but are saved
as clockwise directions.
V.A. Setting Sets the vertical angle.
Zenith
Zenith=0°; Horizon=90°.
Horizont
Zenith=90°; Horizon=0°.
Vertical angles are positive above the horizon
and negative below it.
Slope [%]
45°=100%; Horizon=0°.
Vertical angles are expressed in % with posi-
tive above the horizon and negative below it.

The % value increases rapidly. --.--%
appears on the display above 300%.
V After MEAS Sets if the vertical angle value recorded is the value that is displayed when MEAS or
when REC is pressed. The vertical angle field in a measurement screen always shows
the running angle, regardless of this setting.
Hold The vertical angle value that is recorded is the value that was in
the vertical angle field at the time MEAS was pressed.
Free The vertical angle value that is recorded is the value in the
vertical angle field at the time REC is pressed.
90°
270°
180°
0°
45°
180°
+90°
-90°
+45°
-45°
0°
Slope %
+300 %
+100%
+18 %
0°
-100 %
-300 %
20°
45°
71°34”
360s
gon
-50 gon
-79,5 gon
--.--%
--.--%
±VA