Safety Directions Zoom20/30/35 Pro | 9
1.6 Laser Classification
1.6.1 General
General The following chapters provide instructions and training information about laser safety according to inter-
national standard IEC 60825-1 (2014-05) and technical report IEC TR 60825-14 (2004-02). The informa-
tion enables the person responsible for the product and the person who actually uses the equipment, to
anticipate and avoid operational hazards.
1.6.2 Distancer, Measurements with Reflectors
General The EDM module built into the product produces a visible laser beam which emerges from the telescope
objective.
The laser product described in this section is classified as laser class 1 in accordance with:
• IEC 60825-1 (2014-05): "Safety of laser products"
These products are safe under reasonably foreseeable conditions of operation and are not harmful to the
eyes provided that the products are used and maintained in accordance with this User Manual.
Labelling
According to IEC TR 60825-14 (2004-02), products classified as laser class 1, class 2 and class 3R
do not require:
• laser safety officer involvement,
• protective clothes and eyewear,
• special warning signs in the laser working area
if used and operated as defined in this User Manual due to the low eye hazard level.
National laws and local regulations could impose more stringent instructions for the safe use of
lasers than IEC 60825-1 (2014-05) and IEC TR 60825-14 (2004-02).
Description Value (Zoom20/30 Pro
A2/ A4/A6)
Value (Zoom20, Zoom35
Pro A4/A10)
Maximum average radiant power 0.33 mW 0.33 mW
Pulse duration 400 ps 800 ps
Pulse repetition frequency 320 MHz 100 MHz - 150 MHz
Wavelength 658 nm 658 nm
a) Laser beam
Pav = 4.8mW λ = 658nm tp = 800ps
IEC 60825-1:2014
Designed in Switzerland /Made by Hexago n in China
Complies with FDA perfo rmance standar ds for laser products
except for deviations pursuant to Laser N otice No. 50, dated
June 24, 2007.
This device compl ies with part 15 of the FCC Rules .
Operation is subject to the following two conditions:
(1) This device may not cause har mful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
123456
S.No.:
123456
Art.No.:
Equip.No.: 1234567
Power: .....V , ...A max.
GeoMax AG
CH-9443 Widnau
Manufactured: 20XX
Type: ZOOM XX Pro
009296_001
a
To Next Page
Loading...
Need help?
General
