Settings Zoom20/30/35 Pro | 29
Tilt and horizontal
corrections
5.2 EDM Settings
Description The settings on this screen define the active EDM, Electronic Distance Measurement. Different settings for
measurements are available with Reflectorless (RL) and Prism (IR) EDM modes.
Access 1) Select Settings from the MAIN MENU.
2) Select EDM from the Settings menu.
EDM SETTINGS
Double PtID Sets if multiple points are able to be recorded with the same point ID in the same job.
Allowed Allows multiple points with the same point ID.
Not Allowed Does not allow multiple points with the same point ID.
Sort Type Time Lists are sorted by time of entry.
Pt Lists are sorted by Point IDs.
Sort Order Descending Lists are ordered in descending order of sort type.
Ascending Lists are ordered in ascending order of sort type.
Pre-/Suffix
Only used for Setout program.
Prefix Adds the character entered for Identifier in front of the original
point number of the point to be staked.
Suffix Adds the character entered for Identifier at the end of the orig-
inal point number of the point to be staked.
Off The staked point is stored with the same point number as the
point to be staked.
Identifier
Only used for Setout program.
The identifier can be up to four characters and is added at the start or end, of a point
number of a point to be staked.
Field Description
Setting Correction
Tilt correction Horizontal
correction
Incline longitu-
dinal
Incline trans-
versal
Horizontal
collimation
Tilting axis
Off On No No Yes Yes
1-Axis On Yes No Yes Yes
2-Axis On Yes Yes Yes Yes
Off Off No No No No
1-Axis Off Yes NoNoNo
2-Axis Off Yes NoNoNo
ATMOS
To enter atmospheric data ppm.
PPM
To enter an individual ppm value.
SCALE
To enter projection scale details.
FREQ.
To view the EDM frequency.
Field Description
Mode IR-Default Fine measuring mode for high precision measurements with prisms.
IR-Quick Quick measuring mode with prisms, with higher measuring speed
and reduced accuracy.
IR-Continuous For continuous distance measurements with prisms.
Foil For distance measurements using Retro reflective targets.
To Next Page
Loading...
Need help?
General
