EasyManuals Logo
Home>GeoMax>Measuring Instruments>Zoom20 Pro Series

GeoMax Zoom20 Pro Series User Manual

GeoMax Zoom20 Pro Series
104 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Zoom20/30/35 Pro | 2Introduction
Introduction
Purchase Congratulations on the purchase of a GeoMax Zoom instrument.
This manual contains important safety directions as well as instructions for setting up the product and
operating it. Refer to "1 Safety Directions" for further information.
Read carefully through the User Manual before you switch on the product.
Product identification The type and serial number of your product are indicated on the type plate.
Always refer to this information when you contact your agency or GeoMax authorised service workshop.
Trademarks Windows is a registered trademark of Microsoft Corporation in the United States and other countries
Bluetooth
®
is a registered trademark of Bluetooth SIG, Inc.
SD Logo is a trademark of SD-3C, LLC.
All other trademarks are the property of their respective owners.
Validity of this manual
WARNING
Description
General This manual applies to Zoom20 A4, Zoom20 Pro, Zoom30 Pro and Zoom35
Pro instruments. Where there are differences between the instruments
they are clearly described.
The appearance of the products is subject to change without
notice. The appearance of the actual product may vary slightly
from the product shown in the illustrations.
Telescope Measuring with IR modes: When measuring distances to a reflector
with Electronic Distance Measurement (EDM) mode "IR", the telescope
uses a wide visible red laser beam, which emerges coaxially from the
telescope's objective.
Measuring with RL modes: Instruments that are equipped with a
reflectorless EDM additionally offer the EDM mode “Reflectorless (RL)”.
When measuring distances with this EDM mode, the telescope uses a
narrow visible red laser beam, which emerges coaxially from the tele-
scope's objective.
Do NOT remove the battery during operation of the instrument, or during the shutdown procedure.
This can result in a file system error and data loss!
Always switch off the instrument by pressing the On/Off key, and wait until the instrument has shutdown
completely before removing the battery.
Zoom_019

Table of Contents

Other manuals for GeoMax Zoom20 Pro Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GeoMax Zoom20 Pro Series and is the answer not in the manual?

GeoMax Zoom20 Pro Series Specifications

General IconGeneral
BrandGeoMax
ModelZoom20 Pro Series
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals