Installation & Service Manual
107
Remote Aux Panels
For configuration, see Install Remote Aux Panel Software, on page 142.
GV-RAP-100 and GV-RAP-200 Remote Aux Panels
The GV-RAP-100 and GV-RAP-200 have the same rear panel layout.
PS1
DC
IN
PS2
FRAME ID
ETHERNET
REMOTE AUX PANEL
GV-RAP-100
FABRIQUÉ AU CANADA / MADE IN CANADA
THIS DEVICE C OMPLIES WITH PART 1 5 OF THE FCC RU LES.
OPERATION IS SUBJECT TO T HE FOLLOWING TWO
CONDITIONS: (1) THIS D EVICE MAY NOT CAUSE HA RMFUL
INTERFERENC E, AND (2) THIS DEV ICE MUST ACCEPT AN Y
INTERFERENCE RECEIVED, INCLUDING IN TERFERENCE
THAT MAY CAUSE UNDESIRED OPERAT ION.
ASS’Y
QC.
SERIAL NO.
11-06150-090
GPI I/O 1-8
GPI I/O 9-16
Remote Aux Panel Power Supply AC Requirements
The GV-RAP-100 and GV-RAP-200 external Power Supply is power factor corrected and
automatically accommodates low line (120V nominal) or high line (240V nominal). The
power supply has a rating of 100 – 240 volts, although it is designed and tested for a range
of 90 to 264 volts to accommodate under and over voltage conditions. GV-RAP Aux panels
are supplied with one power module. An optional second power module can be added for
redundancy (n+1).
Supplied Power Cables
The GV-RAP-100 and GV-RAP-200 external Power Supply has IEC C14 sockets. Cables
provided are matched to the destination country’s standard. For example, in the USA C14 to
NEMA 5-20P cables are provided.
Ethernet Requirements
Cable type: 10BaseT, 100BaseT, 1000BaseT compatible Category 5 cable, 8 conductor
twisted pair.
The system will work at lower ratings with reduced performance. 1000BaseT components
are highly recommended.
To Next Page
Loading...
