Installation & Service Manual
283
1 Select Eng Setup, Router.
The Status indicator is red when communication is not detected, and goes green when
communication is established.
To Set the IP Addresses:
2 Select the
Primary IP data pad and enter the primary address of the router with the
pop-up keypad.
3 Select the
Secondary IP data pad and enter the secondary IP address of the router, if
appropriate. If the router has only one control system, leave this address set to the
blank default.
Note: If the GV Switcher system has been configured with a router IP
address but a connection to the router has not been established, changing
the IP address in this menu will not make the switcher system immediately
try to connect to the new router address. The system will automatically try to
connect after about 30 seconds using the entered router IP addresses.
Primary and Secondary Router Communications
The GV K-Frame XP switcher system will initially use the primary router control system IP
Address for communications. If the primary router control system fails to respond, the
switcher will attempt to use the secondary IP address for communications. If successful, it
will continue using it in the future. If ever communication is lost to the secondary, the
switcher will attempt to reestablish communications using the primary IP Address.