Basic Configuration
Configure the IP Board SFPs
148
Configure the IP Board SFPs
IMPORTANT: Each IP board with Dual-use SFPs must be configured as
either all 10GbE or all 25GbE streaming speed, however the boards
can be mixed within the Frame.
1 Select Eng Setup, Video I/O, IP I/O Config in the switcher menu.
2 Select the Port Config SFPs button (below Inputs and Outputs).
3 Select a board from the Video I/O Board or Mod I/O Board (GV K-Frame X) or Video I/O
Board (V-series) button row.
4 In the Board Config button pane, select the
SFP Speed button, choose the configured
SFP speed for the IP board
10GbE or 25GbE, and select Done.
5 Select the
Streams/SFPs in/out button and make a selection (SFP Input/Output Mode
Configuration), select
Done.
6 Select
Apply Settings.
Note: When the Apply Settings button is selected in the Port Config SFPs
menu, the settings for Inputs, Outputs, and SFPs (Video, Audio, and
Ancillary) are applied. Only the changes are sent to the Frame.
If you are attempting to set the IP board to 25GbE and you have 10Gb/s only SFPs, the
system will report an error but still attempt to run at the 25Gb/s speed.
To Next Page
Loading...
