GRASS VALLEY KAYENNE - Configure the Port Config Sfps; Configure System Inputs;Outputs

Basic Configuration
154
Configure the Port Config SFPs
Configure the Port Config SFPs
Perform this procedure before configuring the inputs and outputs:
1 Select
Eng Setup, Video I/O, IP I/O Config.
2 Select Port Config SFPs, Bulk Configuration to display the SFP Port Config Bulk
Configuration menu.
3 In the Board Bulk Configuration menu, enable the
Video I/O or Mod I/O button.
4 Select the
Board Start/Board End button and enter the board in the Video I/O Board
Start
/Video I/O Board End pop-up keypad.
5 Based on the configured throughput speed of the SFPs installed, enable the
SFP Speed
button and select 10GbE or 25GbE.
6 Enable the
Streams/SFPs button and select: (SFP Input/Output Mode Configuration)
•
2 inputs/1 output,
•
4 inputs/2 outputs, or
• 8 inputs/4 outputs.
7 Select
Enter.
Configure System Inputs/Outputs
1 Select Eng Setup, Video I/O, IP I/O Config in the menu.
2 Select the
Inputs or Outputs button to delegate the menu.
3 Navigate to a System Input/Output SFP by selecting a Video I/O or Mod I/O Board
button (bottom) and using the scroll bar or select the SFP data pad (top right) and scroll
with the Menu Panel soft knob or a mouse wheel.
4 Se
lect the Stream Format data pad to select a format (ST 2110-20, ST 2022-6,
4K TICO ST 2022-6.
5 Select the
Enable button for Redundancy.
6 Select the
Receive IP/Transmit IP data pad, enter the IP Address in the pop-up keypad,
and select
Enter.
a If Redundancy Mode is enabled, configure the IP Address for SFP B also.
7 Select the
UDP Port data pad, enter a port number.
8 Select Enter.