GRASS VALLEY KAYENNE - Creating an on Air Relay Tally Calculator Using M;Es or PGM;PST

Installation & Service Manual
177
Creating an On Air Relay Tally Calculator Using M/Es or PGM/PST
Selecting an On Air Tally or Tally Calc 1-4 tab delegates the menu controls to the selected
calculator as shown below.
Calc On - Turns the delegated Tally Calculator on or off. When on, the Calculation Enables
button on the separate Relay Assign menu will be activated for that calculator.
Groups Enabled - Reports which Tally Groups are currently assigned for that calculator, by
group letter (A, B, C, D, corresponding to Tally/GPI connectors 1-4 on the rear of the GV K-
Frame XP Video Processor). To Enable a Tally Relay Group, it must first be turned on, using
the
Calc On button for that calculator.
The first tally calculator name is fixed to
On Air. Since the On Air Calculator is restricted the
Look Ahead and Bus buttons are disabled (grayed out).
Creating an On Air Relay Tally Calculator Using M/Es or PGM/PST
1 If necessary, login to the desired suite (Eng Setup, Eng Login).
2 Select
Eng Setup, Switcher Tally, On Air Tally to access the On Air Tally menu. The Suite
button for the current suite will be highlighted.
3 Select a
Tributary button on the right.
4 Select an
ME or PGM/PST button on the left.
5 Select an Output button to assign that output of the M/E or PGM/PST to that tributary.
The name of the output is displayed on the Tributary button.
6 R
epeat the steps above for other Tributaries for all the outputs you wish to assign for
On Air Tally.
• Pressing the
None button clears the assignment for that Tributary.
• Pressing the Reset button clears all the assignments to all the Tributaries.